1/11/2024 0 Comments Iostat qutimp allows you to specify a particular device to focus in on. m changes the output to megabytes, which is a bit easier to read and is usually better understood by customers or managers. To clean up the output and make it easier to digest, use the following options: The above output is from a 30-second run. To do this, run the command with the interval (in seconds) at the end: ~]# iostat -m 10ĭevice tps MB_read/s MB_wrtn/s MB_read MB_wrtn It can be useful in troubleshooting or data gathering phases to have a report run at a given interval. Once you combine this knowledge with the output of iostat, you can make changes to your system accordingly. The practical application is this: if you know what hardware is used, then you know what parameters it should be operating within. Also, note that the tps field is the total number of Transfers per second issued to a specific device. The output includes totals, as well as per second values for both read and write operations. It also displays I/O stats for each partition on the system. If you run the base command without options, iostat displays CPU usage information. Sysstat-11.7.86_64 Collection of performance monitoring tools for Linux Lm_sensors-libs-3.4.86_64 Lm_sensors core libraries The following packages have to be installed: Install package 'sysstat' to provide command 'iostat'? y NOTE: the command runs automatically after installation. I am using Red Hat Enterprise Linux 8 here and have included the install output below. iostat is a part of the sysstat package and is not loaded on all distributions by default. For input/output monitoring, we use the iostat command. We know that Linux is loaded full of helpful tools for all manner of issues. I have seen a single replication job take months. If all is well, we are talking hours, if not. However, the throughput of a system can have huge implications for massive data transfers. Now, if you have ever worked in support, you know that there can be many causes for a symptom. Many times, customers would contact me concerned about the speed of the data transfer from production to storage. One of my many tasks in that role was to help customers replicate backups from their production environments to dedicated backup storage arrays. If you have followed my posts here at Enable Sysadmin, you know that I previously worked as a storage support engineer. Cheat sheet: Old Linux commands and their modern replacements.Linux system administration skills assessment.A guide to installing applications on Linux.Download RHEL 9 at no charge through the Red Hat Developer program.COMMAND: The name of the command that started the process.TIME+: How much processor time the process has used.MEM: The percentage of physical RAM used by the process.CPU: The percentage of the processor time used by the process.S: The current status of the process (zombied, sleeping, running, uninterruptedly sleeping, or traced).SHR: How much shared memory the process is using.RES: How much physical RAM the process is using, measured in kilobytes.VIRT: How much virtual memory the process is using.NI: The nice value of the process, which affects its priority.The lower the number, the higher the priority. PID: A process ID number for the process.The following are definitions for each column in the output: The command used to start the process is also included. The htop tool lists all running processes on the system and includes information about how much CPU and memory each process is using.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |